MaxMotorhead
BMW X1 2016 problems again and again the starter does not work
Longer cold start time
Weird engine noise
Dim or flickering lights
Car won't start
Warning light in the speedometer of the vehicle
Weak battery when starting the engine
(Translated from German)
4 comment(s)
Hey, thanks for your answer! My X1 has 189543 km on it and I recently had the fault memory read out. It showed a problem with the glow control unit. The battery has already been replaced, but the problem persists. Could it perhaps also be due to a sensor? I'm not sure whether I should go straight to the workshop or whether I can check something myself. Thanks again and best regards!
(Translated from German)
Hey again, thanks for the additional information. The fact that the glow control unit is displayed as an error can be an important clue. In my X3, it was actually a sensor that had to be replaced. If you have already replaced the battery and the error is displayed with the glow control unit, this could definitely be a clue. A faulty glow control unit can cause various symptoms, especially with cold starts. This could also explain the long starting times and the warning light. I would recommend that you also check the sensor and replace it if necessary. If you are sure and feel confident, you could test or replace the glow control unit yourself. Otherwise, I would really advise you to go to the workshop before you buy any other accessories. This may save you time and nerves. Hope this helps you! Good luck and keep us up to date. Best regards!
(Translated from German)
Let our mechanics help you!
Hey, I had a similar problem with my BMW X3 Diesel, year 2018. I only have a little experience in screwing, but I was able to find out that the error occurred in my case due to an electronic follow-up error ("Error results from a follow-up error of the vehicle electrics"). I then went to my garage, where they fixed the fault free of charge. The diagnosis showed that it was a faulty sensor that was causing the starting problems. After that, everything ran smoothly again. It would be helpful if you could provide more information about your X1. Have you already read out a fault memory or carried out further diagnostics? Then I might be able to give you more tips. Best regards!
(Translated from German)